Hello Guest it is February 07, 2023, 07:11:12 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Johnjackson622

Pages: 1
General Mach Discussion / Have a few problems, need some help please.
« on: April 24, 2013, 09:05:17 AM »
I am using Mach3 with lazycam. I have the license for both of them. Now here are the problems:

1) I can not get lazycam to post a g-code into Mach3. It keeps showing the message "No Mach3 found running". How can I fix this?

2) I started to load my g-code manually from mach3 and that's fine except that whatever I loaded only about half or so would show up. I have noticed that my g-code only went to 5000 lines. So i uninstalled both Mach3 and lazycam then reinstalled them. Now my g-code limit seems to be only 2500 lines.

I am no where near an expert with these programmes. I have went through the entire lazycam manual and also the mach3 manual i was given when I bout the program. If anyone could help I would greatly appreciate it.


Pages: 1