Messages

1

General Mach Discussion / Re: Standalone DTHC Setup

« on: April 15, 2013, 04:48:47 AM »

Anybody can help me??? 

2

General Mach Discussion / Re: Mach 3 personalization and full screen

« on: April 15, 2013, 04:44:48 AM »

Thank u so much hood.

I dont know so much thing about mach 3's detail. And i m trying to learn something.

3

General Mach Discussion / Re: Mach 3 personalization and full screen

« on: April 15, 2013, 01:30:23 AM »

Umm thats well. But i cant using it in full screen right? So i cant hiding the bar top of the screen? I am talking about the bar of at the screen's toppest(writing mach 3 and license number etc.)

4

General Mach Discussion / Re: Standalone DTHC Setup

« on: April 15, 2013, 12:34:03 AM »

Br549;

Thank you for your help.all of that is right.

 But actually the big problem isnt that. Idk how can i set up my mach 3 config and settings.

if i ll connect the arc on signal to pin 5. How can i set up the pin 5 for arc on signal on mach3. And same thing for input signal. How can i set up the pin17 for arc OK signal and pin 18 for THC on/off signal.

5

General Mach Discussion / Mach 3 personalization and full screen

« on: April 14, 2013, 03:19:09 PM »

Hi all

Can i use mach 3 in full screen mode?
 So we are using it in window mode and how can i take it to full screen or can i do it?

6

General Mach Discussion / Re: Standalone DTHC Setup

« on: April 14, 2013, 02:51:23 PM »

Br549;

My thc is xpthc 300 u can look it from here: http://www.hydcnc.com/en/products_1.asp?menuid=18&id=36#ptedian

7

General Mach Discussion / Standalone DTHC Setup

« on: April 14, 2013, 10:32:35 AM »

Hi everyone;

I bought a new standalone THC unit for plasma. But I don't know how can i connect it to Mach 3.

I have two input and two output on my THC unit.;
1-Output from THC to controller. Arc Trans1 and Arc Trans2 to CNC input. That is dry contact relay connection.(I think that is arc OK signal.)
2-Input to THC unit. THC Auto and Arc on signal.(I think they are low effective)

So how should i connect that wires to PC. And if i ll connect the arc on signal to pin 5. How can i set up the pin 5 for arc on signal on mach3. And same thing for input signal. How can i set up the pin17 for arc OK signal and pin 18 for THC on/off signal.

How my THC Working;

Firstly Controller sending the arc on signal to THC and THC unit piercing the material. After pierce , THC sending a Arc OK signal to controller and controller sending movement signal to x and y axis' driver.

Notice: Actually I have two more cable but I don't know how is that working and is that input or output signal. That cables are up and down.

Sorry about my bad Eng. I ll wait help.

Thank you..