241
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: February 19, 2015, 09:01:10 PM »
Sage:
Yes, 1.21 over 1.23 is the correct version numbers. If you run the setup or the diags you should have a pulse frequency shown
when you slide the slider it should change. I cant imagine why the driver woudl show a zero count, unless its stuck in memory.. did you
reboot?
Art
Yes, 1.21 over 1.23 is the correct version numbers. If you run the setup or the diags you should have a pulse frequency shown
when you slide the slider it should change. I cant imagine why the driver woudl show a zero count, unless its stuck in memory.. did you
reboot?
Art