Messages

1691

General Mach Discussion / Re: help with MaxNC 10 O.L. 2005

« on: March 27, 2006, 08:18:06 PM »

Hi,

Pinouts look the same..
 
I suspect the only difference is ou need ot set the enable lines properly to trigger the motor enables and pic reset lines..

Art

1692

General Mach Discussion / Re: Getting New Installation Going

« on: March 14, 2006, 06:06:10 AM »

Hi:

  That "Bad" screen is fine. This is a very good result. Dont worry further about the state of the computer as far as the driver is concerned.

Looks like we're not going to see the "Cluynk" time on the drivertest. That small dip would not be heard. One of the funny things about all this stuff, is if the
CPU is getting shut down intermittantly, you may not see the time spike. If you command a long move on only the X axis, how often does it thunk..?

Art

1693

General Mach Discussion / Re: Getting New Installation Going

« on: March 13, 2006, 11:26:07 AM »

Hi Guys:

  I suspect your timing is not good. Run the drivertest.exe. Are you sure its showing a line with no hugh spikes of timeing variation??

Thnaks
ARt

1694

General Mach Discussion / Re: Win a G-Rex ( Competition)

« on: February 28, 2006, 07:23:34 AM »

Andy:

   Your very welcome. And thak you!, from frozen Canada.

Art

1695

General Mach Discussion / Re: Win a G-Rex ( Competition)

« on: February 27, 2006, 09:04:01 PM »

John:

  You were within a very small squeaking distance..
Art

1696

General Mach Discussion / Re: Win a G-Rex ( Competition)

« on: February 27, 2006, 06:08:13 PM »

And the winner is....

 Capt_Chaos..

 Way to go Cap'n. Looks very nice. Can you send me (offlist) to fenerty@artofcnc.ca , your real mailing address , as well as any original graphics files for this in pretty much any format.

My thanks to all the submitters, good job on all counts. The Capn's entry was just good enough to swing the vote. Myself and Benny picked the same one in the end, (and the same second place, though
I wont announce that, no sense rubbing it in that somene was that close...

 Thanks everyone, good competion...

Regards,
Art