1
General Mach Discussion / Converting a Probotix Fireball Comet to MACH3
« on: April 12, 2013, 09:57:43 PM »
Hello,
Has anyone converted a Probotix Fireball Comet to MACH3 from EMC2?
I was told that MACH3 couldn't run this little table due to the dual Y axis steppers. I had a Plasmaroute table with a dual Y axis stepper and MACH3 didn't have any issue with it. What I am hoping for is that someone has a configuration file I could try.
https://www.probotix.com/FireBall_Comet_cnc_router/
Thank you,
Has anyone converted a Probotix Fireball Comet to MACH3 from EMC2?
I was told that MACH3 couldn't run this little table due to the dual Y axis steppers. I had a Plasmaroute table with a dual Y axis stepper and MACH3 didn't have any issue with it. What I am hoping for is that someone has a configuration file I could try.
https://www.probotix.com/FireBall_Comet_cnc_router/
Thank you,