11
General Mach Discussion / Re: Input pin help
« on: April 12, 2013, 01:26:06 PM »
Thanks for the advice.
Unless there is somewhere else to check for conflicts pin 13 is not assigned anywhere else in ports and pins.
Defo enabled and set for active low. When I check the diagnostic page the digitise led is on with nothing connected anywhere.
I'm stuck!
Unless there is somewhere else to check for conflicts pin 13 is not assigned anywhere else in ports and pins.
Defo enabled and set for active low. When I check the diagnostic page the digitise led is on with nothing connected anywhere.
I'm stuck!