Topics

1

General Mach Discussion / moveing z axis up and down

« on: October 05, 2007, 05:05:01 PM »

does anyone know about a stepper driver  , that will drive a stepper motor forward and reverse with out the use of a computer.   with a manual push button controller ,,:forward button and reverse button and speed.. simple and cheap...   to manual control my z axis..seperate from the computer driveing the x and y

2

General Mach Discussion / manual z axis

« on: May 05, 2007, 08:44:54 PM »

useing  mach 2 to control plasma table , just hooked up z axis. Can
anyone tell me if you can manual contol the z up and down while a
code is running.. if so how? setting up g code with sheet cam if
that matters...