Hello Guest it is March 29, 2024, 08:54:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - maxpower

Pages: 1
1
General Mach Discussion / 305 motor stalling
« on: March 31, 2013, 06:24:45 AM »
HI
I'm just starting out with CNC, I currently have Hobbycnc board, I'm having trouble getting my X axis to run smoothly.
my y axis 205 stepper motor 3V 3A runs perfectly
my X axis is a 305 stepper motor 4.2V 3A
it runs in jog mode fine but when running a test g code it stalls and vibrates
I have tried changing the velocity and the acceleration, but I can either get it to run smoothly at low speeds or at high speeds but never both

Pages: 1