Topics

1

SmoothStepper USB / Smoothstepper and G50/G51

« on: February 05, 2014, 08:30:37 PM »

Hello all,

Will the smoothstepper support G50 and G51 for axis scaling with Mach3?

Thanks,
Rich

2

General Mach Discussion / planet-cnc USB controller

« on: February 04, 2014, 07:10:21 PM »

Hello All,

I have a customer with set of motors and control box sourced by Probotix.   The control box has a planet-cnc USB control card as its input and stepper control.   The software provided does not do everything we need, and Mach3 will.    Is it possible to run the planet-cnc USB card with Mach3?

Richard

3

General Mach Discussion / RS232 fro gcode to serial port

« on: June 14, 2013, 06:05:20 PM »

Hello Group.

Is there a way to ASCII data from G-code to a serial port for RS232 communications between the Mach3 program and an external device?

Thank you in advance

4

General Mach Discussion / How do I assign an m-function to a parallel port pin?

« on: April 04, 2013, 01:28:02 AM »

I am configuring a new install of Mach3 with steppers and the parallel port.  I have the X-Y motors working fine but I need to assign pin8 and pin9 to specific M-functions.   How do I assign M3 to turn pin 8 on, and M5 to turn it off, and the same for pin 9 with and M#?

Also, where can I find information on customizing screens?