Hello Guest it is March 28, 2024, 06:23:46 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Pysiek

Pages: « 1 2 3 4 »
11
It's not a first time I did that so I believe it is correct. Send an email to Keling and see what they say.

12
Used that wiring diagram to put the wires together: http://www.automationtechnologiesinc.com/docs/schematics/KL-4030Wiring.pdf

13
I did check the wiring again right now and it looks like I did it correctly

14
How do I check if I did not connect the motor cables incorrectly?
On the wiring diagram it shows to use black,green,red and blue wires to connect the motors. But on my motors I have more that
http://www.automationtechnologiesinc.com/wp-content/uploads/downloads/2012/08/KL-4030WithC10.pdf

15
Yes tweakie. I already check everything with meter

16
Nothing Brett...I gave up :-(

17
I'm I wrote it wrong. I did put the leads between pins 3 and the 5V. And that was the reading

18
I'm by the machine right now so if somebody can help I will answer right away

19
Here is a screen of my "diagnostics" tab in mach3. Maybe it will tell you something. I took it when everything was on.ready to go.

20
When I put the reading pins to pin 2 & 3 and I try to jog the voltage reading jumps from 5.18 to 5.17-5.16

Pages: « 1 2 3 4 »