1
General Mach Discussion / Re: Mach3 Soft Limits -- Not Stopping
« on: March 22, 2013, 08:47:11 AM »
Update:
Steve at Stepper3 responded to my follow-up email:
I like that they quickly got a software revision out to address the issue (even if it was just a partial fix), and then moved on to the more involved hardware fix. It sounds like they're heading in the right direction to get the soft limits functioning properly.
Steve at Stepper3 responded to my follow-up email:
Quote from: Steve @ Stepper3
we do have the intent to take a more thorough approach to fixing the soft limits issue. However, it will require a firmware revision to our ethernet board, that will require a user to send the board back to reprogram. I am working on a revision C of the ethernet board, that I intend to have out soon, that will address the issue.
I wanted to address the softlimits quickly for you, which is why we put the 1.1 revision out.
I like that they quickly got a software revision out to address the issue (even if it was just a partial fix), and then moved on to the more involved hardware fix. It sounds like they're heading in the right direction to get the soft limits functioning properly.