Messages

101

General Mach Discussion / Re: Panasonic servo drive help

« on: March 19, 2013, 05:57:05 PM »

Hopefully one last BIG shot of the base.

102

General Mach Discussion / Re: Panasonic servo drive help

« on: March 19, 2013, 05:54:13 PM »

overall shot of the whole project & messy basement. Can you tell by the pic sizes I'm still learning?

103

General Mach Discussion / Re: Panasonic servo drive help

« on: March 19, 2013, 05:50:44 PM »

left to right,base-x axis rails & ballscrew-z axis rails & ballscrew-gantry

104

General Mach Discussion / Re: Panasonic servo drive help

« on: March 19, 2013, 05:42:28 PM »

Different angle of base

105

General Mach Discussion / Re: Panasonic servo drive help

« on: March 19, 2013, 05:36:56 PM »

Here's a shot of the base so far,Y axis rails & ballscrew just sittin' there for now.

106

General Mach Discussion / Re: Panasonic servo drive help

« on: March 19, 2013, 06:53:52 AM »

Hot Damn,bout time!
     I'll try a couple more tonight.Thanks for putting up with my "learning process".
                                Rick

107

General Mach Discussion / Re: Panasonic servo drive help

« on: March 19, 2013, 06:50:45 AM »

Well here I go again! Maybe you see my mock-up & Mach3 computer?
                  Rick

108

General Mach Discussion / Re: Panasonic servo drive help

« on: March 18, 2013, 10:07:49 PM »

I should've known. I read if I did that it should put a thumbnail in a post,obviously didn't work for me.
                 Good Nite. Rick

109

General Mach Discussion / Re: Panasonic servo drive help

« on: March 18, 2013, 10:04:34 PM »

Bear with me folks.it's an experiment.  Rick





[timg]C:\Users\Rick\Pictures\mockup2.JPG[/timg]

110

General Mach Discussion / Re: Panasonic servo drive help

« on: March 18, 2013, 08:06:28 PM »

Are you kidding me!!
    That's crazy,I never seen that trick before,thanks for the good sense of humor Hood.Brett, I haven't checked the links yet but I will. I need the photo education and buying shielded twisted pair cabling by the foot is tough to find,I bought the cable for the encoder used off e-bay cause everybody selling new wanted to sell me a 500' roll, I didn't need quite that much!
                                   Rick