Guest
Show Posts
1
General Mach Discussion / G83 Random Bug
« on: March 15, 2013, 04:25:01 AM »
Machine :Matchmaker 800 Vertical Mill
Using Machmotion Ultimate screen
Hello,
I am a new user of Mach 3 it has been recently retrofitted to replace an old Ah Ha system.
Everything works fine except:
When using G83 peck drilling cycle IE.
T3M6
G0G90X0.Y-10.A0.S1500M3
G43H3Z2.M8
G99G83Z-29.R2.Q2.F100.
G80
The control will work perfectly for any random number of components and then do this:
Feed approach to feed plane
Rapid to peck depth
Rapid out
Which it then repeats to the full depth of the hole.
This breaks drills.
It is as if the Feed and Rapid get reversed.
The most strange thing is that the frequency of this problem is completely random.
Sometimes it works fine from the start then changes. Other times the problem is there from the first component.
I would appreciate any help or suggestions.
Thank you
Dennis
Using Machmotion Ultimate screen
Hello,
I am a new user of Mach 3 it has been recently retrofitted to replace an old Ah Ha system.
Everything works fine except:
When using G83 peck drilling cycle IE.
T3M6
G0G90X0.Y-10.A0.S1500M3
G43H3Z2.M8
G99G83Z-29.R2.Q2.F100.
G80
The control will work perfectly for any random number of components and then do this:
Feed approach to feed plane
Rapid to peck depth
Rapid out
Which it then repeats to the full depth of the hole.
This breaks drills.
It is as if the Feed and Rapid get reversed.
The most strange thing is that the frequency of this problem is completely random.
Sometimes it works fine from the start then changes. Other times the problem is there from the first component.
I would appreciate any help or suggestions.
Thank you
Dennis