Messages

61

LazyCam (Beta) / Re: LazyCam 2.01 Lathe

« on: May 26, 2007, 02:58:47 AM »

whew i finally got Lcam turn to work, its really cool once you get it.

thanks

62

LazyCam (Beta) / Re: LazyCam 2.01 Lathe

« on: May 25, 2007, 09:53:52 PM »

Chip thanks for the .tap file

63

LazyCam (Beta) / Re: LazyCam 2.01 Lathe

« on: May 25, 2007, 09:40:38 PM »

Hmm ok i was looking for the .lcam file to see what settings you are using
I loaded that .dxf file and when i get to mach its excatly opposite of what i see on yours.

64

LazyCam (Beta) / Re: LazyCam 2.01 Lathe

« on: May 25, 2007, 09:17:51 PM »

Chip can you post your .lcam file please

65

LazyCam (Beta) / Re: OK, I give up! How do I get ACAD dxf files to open in LCAM 2.02?

« on: May 25, 2007, 07:44:47 PM »

I use IntelliCAD but it will save/export just about any version of ACAD file, i use the 2004version.  I was having the same problem and switched to the export as a last ditch effort and haven't had any problems since.

66

LazyCam (Beta) / Re: OK, I give up! How do I get ACAD dxf files to open in LCAM 2.02?

« on: May 25, 2007, 07:11:00 PM »

I don't know if this helps or not but when i use the save as command for the dxf file, it won't import however if i use export to a dxf file Lcam will import no problem.  The file size is only slightly different.  I don't know what the difference the difference is between save as versus export.  I just know the Lcam will open the export but not the save as file.