Messages

21

G-Code, CAD, and CAM discussions / Re: Help writing G-Code

« on: June 19, 2007, 03:09:06 AM »

sorry fingers to fast, y got in there by accident.

Wes

G0 X0
M98 P69 L100
M2
%

O69
G0 X1.0
G0 X0.0
M99
%

22

G-Code, CAD, and CAM discussions / Re: Help writing G-Code

« on: June 19, 2007, 03:07:39 AM »

here ya go

G0 X0 Y
M98 P69 L100
M2
%

O69
G0 X1.0
G0 X0.0
M99
%

23

LazyCam (Beta) / Re: General Offsetting Procedure

« on: June 19, 2007, 01:02:39 AM »

its always make more sense while your trying to do something.  Just reading through them the first time kinda like water on a duck.

Wes

24

LazyCam (Beta) / Re: Lcam Rev 2.02

« on: June 19, 2007, 12:59:35 AM »

I think it is the way it was drawn I found another source for the airfoils and thier dxf are working correctly.

Wes

25

LazyCam (Beta) / Re: Lcam 2.0...

« on: June 18, 2007, 11:19:40 PM »

Art or anybody
how do you fix this heart so it will import into lcam.

Thanks

Wes

26

LazyCam (Beta) / Re: LCam pro turn problem

« on: June 18, 2007, 10:32:02 PM »

sorry here is the correct one.   I did figure out what was causing it though.  it does this when you input a tip radius of 0.00000.

Wes

27

Third party software and hardware support forums. / Re: Syil X2 cnc controller question

« on: June 18, 2007, 05:25:48 PM »

start easy then hit the Diag page and see if any leds are lit

Wes

28

Third party software and hardware support forums. / Re: Syil X2 cnc controller question

« on: June 18, 2007, 05:00:18 PM »

Don't know if it helps but i get that message when i unplug the power to my breakout board.

Wes

29

LazyCam (Beta) / Re: LCam pro turn problem

« on: June 18, 2007, 04:34:23 PM »

Art here is the pics
Wes

30

G-Code, CAD, and CAM discussions / Re: Help writing G-Code

« on: June 18, 2007, 02:04:05 PM »

smr what codinates do you want it to go to?

Wes