Hello Guest it is July 04, 2022, 12:16:16 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wnevels

Pages: « 1 2 3 4 5 6 7 »
11
General Mach Discussion / Re: Charge pump pmdx 131
« on: July 12, 2007, 08:01:15 PM »
Wow i also got a reply today with the same message.

let me know how it goes.

Wes

12
General Mach Discussion / Re: Charge pump pmdx 131
« on: July 12, 2007, 02:18:41 PM »
I just sent pmdx a support request.  Which may or may not be answered.  As much as i like PMDX boards the support is lacking i'm still waiting on a answer from about a year ago.


13
General Mach Discussion / Re: Charge pump pmdx 131
« on: July 12, 2007, 02:12:21 PM »
I still have it bypassed no solution yet.

Wes

14
LazyCam (Beta) / Re: G-Code line limitation???
« on: June 22, 2007, 01:05:01 PM »
500 line limit

15
Ya know i was all happy with my tool change macro.  Then i ran a G21 program and ka boom.  Some days it just doesn't pay.
I give up and i'm going to get my boat and hope it doesn't know any g, m, or vb codes.

When i get back i'll start working on a if then statement

Wes

16
General Mach Discussion / Re: Speed Control of Omron inverter
« on: June 21, 2007, 08:15:30 PM »
Try calling Omron and tell them what you got and what you want.  I've called them a couple times and they have been friendly and very helpful even though it was just me.

Wes

17
General Mach Discussion / Re: two motors one drive?
« on: June 21, 2007, 08:12:19 PM »
I've never tried that, but you can always slave another axis to the X.
I haven't cut any metal yet but that was the way I was gonna do my router table when i get around to making one.

Wes

18
G-Code, CAD, and CAM discussions / Re: Help writing G-Code
« on: June 19, 2007, 05:45:16 PM »
I really couldn't tell you one way or the other. 
I would suggest click tutorials>Documetation above, then download using Mach2 and customizing mach2  somewhere in the pdf it should have the info on increasing stepper speed.

Wes

19
G-Code, CAD, and CAM discussions / Re: Help writing G-Code
« on: June 19, 2007, 03:24:05 PM »
go to motor tuning and slide the velocity up.
Unless you just have your heart set on running mach2 you should upgrade to Mach3

20
G-Code, CAD, and CAM discussions / Re: Help writing G-Code
« on: June 19, 2007, 02:43:42 PM »
never run Mach2 i've always run Mach3 maybe somebody else is familler with the motor tuning in Mach2

Pages: « 1 2 3 4 5 6 7 »