Hello Guest it is April 24, 2024, 03:52:44 PM
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
| Filename | Downloads | Message |
Posted
|
|---|---|---|---|
| arc_void.JPG | 463 | Re: LazyCam 2.01 Lathe | May 26, 2007, 05:37:54 PM |
| airfoil.JPG | 590 | Re: Lcam Rev 2.02 | May 27, 2007, 03:32:25 PM |
| Airfoil_with_pockets_and_offests.JPG | 448 | Re: Lcam Rev 2.02 | May 29, 2007, 12:07:30 AM |
| turn_offset.JPG | 544 | Re: LCam pro turn problem | June 11, 2007, 05:35:43 PM |
| mt3_tamper_lcam.dxf | 223 | Re: LCam pro turn problem | June 15, 2007, 01:07:25 PM |
| clark-y.dxf | 278 | Re: Lcam Rev 2.02 | June 17, 2007, 03:52:47 AM |
| clark_y.JPG | 526 | Re: Lcam Rev 2.02 | June 17, 2007, 03:52:47 AM |
| g42_cutter_comp.JPG | 525 | Re: G code cutter comp problem | June 17, 2007, 10:41:17 PM |
| turn_offset_groving.JPG | 502 | Re: LCam pro turn problem | June 18, 2007, 04:34:23 PM |
| 1st_side_oil_temp_adapter.dwg | 185 | Re: LCam pro turn problem | June 18, 2007, 04:34:23 PM |
Guest