1
General Mach Discussion / centre part on table (probably a silly question)
« on: July 04, 2018, 12:35:36 AM »
Hi Forum,
i have headed back to the workshop and it appears i have forgotten a lot... :-(
I loaded G-code (all good)
set my XYZ DRO to zero on centre of part etc.. (seems ok)
set machine coordinates to 0.000 (to DRO)
but.......
my part is still showing at the edge of the table which appears to be causing all sorts of odd moves.....- see attached
Q... How to i set do my part is centered on the table?
i have headed back to the workshop and it appears i have forgotten a lot... :-(
I loaded G-code (all good)
set my XYZ DRO to zero on centre of part etc.. (seems ok)
set machine coordinates to 0.000 (to DRO)
but.......
my part is still showing at the edge of the table which appears to be causing all sorts of odd moves.....- see attached
Q... How to i set do my part is centered on the table?