Hello Guest it is March 29, 2024, 04:06:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ldsanders2807

Pages: 1
1
General Mach Discussion / Safe_Z ignored
« on: February 21, 2013, 09:18:54 AM »
I'm working on an initial setup of Mach3 in a new project.  I have all 4 steppers (one is slaved to X) working, E-stop and limit switches are functioning and all seems to be working well.  What is it saying that needs to be changed when the message "Safe_Z ignored, Z already higher than Safe_Z setting?  Another observation is that after an E-Stop is inititated and I click the "send printer home", that the Z axis does not move to the safe Z location.  Thanks

Pages: 1