11
SmoothStepper USB / Re: ess mach 3 and win 8
« on: April 10, 2013, 12:28:12 PM »
I don't need to try and type from my phone. sorry Jeff. one problem i found was wiring between the ss and the board. i double checked everything and there are more lights on ( thats good i think) now i just realized that i have 2 ports with the ss and the instructions i have are for 1 port. i try and run the configurator (in bootp mode) and it is not getting a response however when i ping it it gets back all of the packets. i just don't know enough to figure out how to configure. when i run the test button i get movement which leads me to believe it is somewhere either in software (and configuring which i know is part of it.) i just would like someone to help point me on how to setup for 2 ports and start to move in the right direction. Thank you Jeff and sorry about the garbled message !!-Andy