Hello Guest it is March 19, 2024, 07:02:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ljh34465

Pages: 1
1
Promote and discuss your product / Re: New TLO setter
« on: August 31, 2013, 09:51:52 AM »
Does Wildhorse furnish the macro?

2
Promote and discuss your product / Re: New TLO setter
« on: August 31, 2013, 07:40:39 AM »
Does the Wildhorse probe automatically enter Tool Length Offset measurements in the tool table?  This saves a lot of time and more importantly avoids fat-finger entry errors.  If it does it’s a great deal (assuming it’s reasonably accurate), if it doesn’t, not so much!

3
General Mach Discussion / FYI
« on: February 04, 2013, 01:27:59 PM »
Just thought some of you that are interested in using Tool Length Offsets there’s an interesting thread going on at the cncZone; http://www.cnczone.com/forums/showthread.php?p=1231306#post1231306

Pages: 1