29
« on: December 06, 2016, 02:10:11 PM »
Hi penkomitev,
Thank you for your interest, it's important for me.
About A/C table version, currently in stand by because the B/C head version is in development and it take a lot of time. After i will return to A/C version.
The good new about the B/C head version, it should be available in few days. The time also to add one or two pages on my website becouse there are some things to show.
As the head is tiltable it was necessary to remake movements in the tool axis.
To know
- Movements in the perpendicular plane of the tool axis with display of the position of the tool tip in this plan
- Movements in the no perpendicular plane of the tool axis with display of the position of the tool tip in this plan
- Drilling cycles : G81 G82 G83 G99 G98
- Tool length compensation G43
- Tool radius compensation G41 G42 in perpendicular plane of the tool axis
- enable RTCP G43.4
- disable RTCP G49
- Display Toolpath in the simulation screen
- Display Toolpath with G41 G42
- Offset of the origin in the work plan (perpendicular plane to the tool axis or no perpendicular plane to the tool axis)
- Label, subprogram call by label, label loop, loop and imbricated loop
- MDI commands
- Editor
- Tool library
- Simulation with different forms of tools : cylindrical, spherical, conical, dovetail, T slot.
So, all in details, soon on my website.
Best regards, Richard.
Guest
Show Posts