Hello Guest it is March 28, 2024, 10:19:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Kenneth

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 »
71
General Mach Discussion / Re: Motor whistling only with Mach3
« on: August 21, 2014, 07:13:03 AM »
under Config/Motor Tuning you're able to adjust the velocity and acceleration.
i had some noise and that helped me.
good luck !

try retuning the motors.
hope this helps !

Do you mean try to modify stepper motor wiring ?!

72
General Mach Discussion / Re: - fixture save...
« on: August 18, 2014, 06:59:35 AM »
thanks again Hood !

73
General Mach Discussion / Re: - fixture save...
« on: August 18, 2014, 05:19:12 AM »
Thanks !

74
General Mach Discussion / Re: Motor whistling only with Mach3
« on: August 14, 2014, 01:01:41 PM »
try retuning the motors.
hope this helps !

75
General Mach Discussion / Re: - fixture save...
« on: August 14, 2014, 11:44:55 AM »
that didn't show the option to save.
it does show to end session.
Thanks

76
General Mach Discussion / - fixture save...
« on: August 14, 2014, 11:27:46 AM »
i'm using mach3 r3.043.066.
it never ask me to save fixture. i tried with the option "optional offset save"
checked and un-checked. i created a button(122) so i can save it but would like
to make a safety so it would ask when i close.
 Thanks !

77
Machscreen Screen Designer / Re: Tool DRO problem
« on: March 18, 2014, 08:29:47 AM »
don't know if you solved your problem but....
make sure you're editing the correct profile. i did
that. work a whole day then found was working on
wrong profile. also,if you have mach3 open, you
have to reload the saved set file.
Good Luck

78
Mach SDK plugin questions and answers. / Re: Test Speak
« on: February 10, 2014, 06:21:51 AM »
has "speak" been removed in newest mach3(r3.043.066) ?
it's clicked in gen conf. both allow wave and speech are checked.
i tried a different version and same effect. (none)
there's GOT to be something i'm missing
Thanks !

79
Mach SDK plugin questions and answers. / Re: Test Speak
« on: February 03, 2014, 10:07:56 AM »
i tried another sound file and still no sound with no errors.
i have r3.043.066 now. tried another version and get same results.
any help would be appreciated !

80
VB and the development of wizards / Re: Macropump Interlock - Reg
« on: February 03, 2014, 08:43:22 AM »
please understand i'm new at this.
but.. i think you need to change

If Not(GetInput(1)) And x>0 Then

to

If Not(GetInput(1)) And x=1 Then

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 »