Hello Guest it is September 19, 2021, 09:51:04 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Kenneth

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 »
21
Mach4 General Discussion / Re: Buttons and the script/gcode
« on: February 12, 2019, 07:40:53 AM »
THANKS MN300, that's actually what i need. now i need to look up Lua.
Thanks again !

22
Mach4 General Discussion / Buttons and the script/gcode
« on: February 11, 2019, 01:42:17 PM »
Hello all,
i'm new to mach4(fourth day) and looking to make a button that will make Z go to 0.2 and then
X and Y go to 0. that's it. i tried gcode but it doesn't like dat. and i'm even newer to script.
any help or point in direction would be greatly appreciated.
THANKS



Mach4hobby
win 10
64g
3.4g processor
24 ram

23
Mach Screens / Re: Probe
« on: February 07, 2019, 02:24:25 PM »
i changed the oem and it works but i close mach3 and opened it again and now
ESTOP doesn't work. i had a script for it but i changed it to oem 1021. but still nothing.
THANKS Klaus for your attention and patience !

24
Mach Screens / Re: Probe
« on: February 07, 2019, 02:06:35 PM »
sorry, yes it's the "height probe" button. ok i'll try that.
THANKS.

25
Mach Screens / Re: Probe
« on: February 07, 2019, 01:45:35 PM »
on it's way.

26
Mach Screens / Re: Probe
« on: February 07, 2019, 01:37:09 PM »
it won't let me edit it in mach3. the other buttons i can edit.
Thanks Klaus

27
Mach Screens / Re: Probe
« on: February 07, 2019, 01:30:59 PM »
i didn't think of that. let me try.
Thanks Klaus

28
Mach Screens / Re: Probe
« on: February 07, 2019, 01:18:50 PM »
i get the error message when i use the button in mach3.
its in the error label. where the estop message is.
Thanks Klaus !

29
Mach Screens / Re: Probe
« on: February 05, 2019, 11:23:53 AM »
there are no CRLF at the end of any line. does have NUL at end of file.
THANKS TPS

30
Mach Screens / Re: Probe
« on: February 05, 2019, 05:58:54 AM »
Thanks Tweakie.CNC, i tried that and same error. i think there may be something that
tells the code that there's an end of line.since the error includes the first two lines.
i also have a corner probe button without the "Call" inserted and works fine.
i'm at a lost but will keep looking. Thanks for your info !

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 »