1
General Mach Discussion / Re: Proma THC works in test mode only
« on: February 20, 2013, 10:58:28 AM »
Hi,
I have my voltage set at 97 volts.........I arrived at this by lowering it till it wouldn't work in test mode.........then raising the voltage till it also stopped working. I couldn't find any spec's for voltage in the Everlast manual. My dwell is set at .2sec which I read that your dwell should be the same that it's set at in sheetcam. My setting in H V was 200v I changed it to 300 v like you suggested and nothing changed. I don't know much about this.....but it seems like Mach 3 is not seeing my arc ok signal. I'm wondering if I need a different post processor for sheetcam. I'm using Mach 3 plasma post which says it's for plasma without THC. Just a thought.......like I said I'm a beginner at this and I'm just guessing at this point. I appreciate your trying to help me get this running. If ya think of anything else shoot me an email. If I happen to solve it I'll let ya know.
thanks
Ned
I have my voltage set at 97 volts.........I arrived at this by lowering it till it wouldn't work in test mode.........then raising the voltage till it also stopped working. I couldn't find any spec's for voltage in the Everlast manual. My dwell is set at .2sec which I read that your dwell should be the same that it's set at in sheetcam. My setting in H V was 200v I changed it to 300 v like you suggested and nothing changed. I don't know much about this.....but it seems like Mach 3 is not seeing my arc ok signal. I'm wondering if I need a different post processor for sheetcam. I'm using Mach 3 plasma post which says it's for plasma without THC. Just a thought.......like I said I'm a beginner at this and I'm just guessing at this point. I appreciate your trying to help me get this running. If ya think of anything else shoot me an email. If I happen to solve it I'll let ya know.
thanks
Ned