Hello Guest it is May 17, 2021, 08:45:51 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - thedemri

Pages: 1
1
OK
So I need to increase the acceleration valuse?

Thedemri

2
Thanks Thedemri

3
Hal
Thanks , it worked perfect!



I just spend a day and a half on this problem!  :-[

Thanks again Thedemri

4
Hi
Thanks
its engraving now and it look like it helped a lot!

I will put a picture in 30 minuets.

when do we need to use the G64 insted of the G61?

is there a place that i can put the G61 as a default?

Thedemri

5
hi
thanks , I am a littel bit new be , how do i turn on the G61 ?

Thedemri

6

Hi
I am using sige x2 converted mill with mach 3
I have tried to engrave letters and logo on dual colored plastic.
And I have noticed that the machine doesn’t finish the cut as it suppos to do.

As you can see form the screen picture , the letters have 90 degrees angels on the corners but the cnc is cutting it with a "short cut " to the next points.






The same is happening on the Z axis and it doesn’t finish the letters (or the logo).
I have tried to generate the code with the Lazycam and solidcam and the results are the same.
Any suggestion?

Thanks thedemri

Pages: 1