Guest
Show Posts
1
Mach3 and G-Rex / feed rate overrun
« on: January 12, 2013, 09:40:40 AM »
hello every one
i m new to mach 3, i have assembled all parts n used mach 3 trial version, axis do not move as fast as they should or as fast i want them to move, feed rate it show is 6, then for the given program it simulated expected time say 60 minutes,
then i selected max feed rate over run it show 18...or 300% but still it is slower, simulation expected time show about 40 minutes,it is still not satisfactory, i want to know if paid version of mach 3 allows feed rate overrun more than 300%,[[ my program involves interpolation.. and i have tried by changing velocity and acc time in motor config for each axis ]]
plz reply soon thanks
i m new to mach 3, i have assembled all parts n used mach 3 trial version, axis do not move as fast as they should or as fast i want them to move, feed rate it show is 6, then for the given program it simulated expected time say 60 minutes,
then i selected max feed rate over run it show 18...or 300% but still it is slower, simulation expected time show about 40 minutes,it is still not satisfactory, i want to know if paid version of mach 3 allows feed rate overrun more than 300%,[[ my program involves interpolation.. and i have tried by changing velocity and acc time in motor config for each axis ]]
plz reply soon thanks