Hello Guest it is April 20, 2024, 02:10:13 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - pjbardo

Pages: 1
1
General Mach Discussion / setting up limit switches with a Max nc cl controller is it possible
« on: December 25, 2012, 09:37:58 PM »
I have been running Mach 3 software with my Max NC controller for some time and was wanting to set up limit switches. currently just have a E-stop in the limit socket is it possible to hookup limits to this system?

Pages: 1