1
General Mach Discussion / Re: Mach 3 Closes Without Error
« on: December 24, 2012, 04:51:20 PM »
Thanks guys, I'll run through this stuff over the next few days, havent had a chance to fiddle yet. I did get something new today, but I've probably seen it a handful of times, check out the attachment.
This happened after I ran some extremely simple code (6 holes for tuners in a headstock), then closed the file. Basically, Mach just freezes and eventually dies regardless of what buttons I hit in the error dialog.
Hopefully that makes things clearer.
Thanks!
This happened after I ran some extremely simple code (6 holes for tuners in a headstock), then closed the file. Basically, Mach just freezes and eventually dies regardless of what buttons I hit in the error dialog.
Hopefully that makes things clearer.
Thanks!