Messages

21

General Mach Discussion / Spindle speed control

« on: January 19, 2008, 05:28:37 AM »

how to automatic control spindle speed with this motor? any try it?

22

General Mach Discussion / Re: Spindle control

« on: January 19, 2008, 05:18:54 AM »

thanks stirling, i'll try.

thanks again

23

General Mach Discussion / Re: Trying to get 2nd parallel port card working, need help!

« on: January 19, 2008, 12:30:51 AM »

i have same prolem

24

General Mach Discussion / Spindle control

« on: January 19, 2008, 12:29:51 AM »

How to setting mach 3 control spindle just on and off? thanks for your help

25

General Mach Discussion / Re: Can use both LTP Port

« on: April 14, 2007, 07:30:41 AM »

thanks you very much 

26

General Mach Discussion / Re: Can use both LTP Port

« on: April 13, 2007, 09:48:02 PM »

thanks for your replay . but i had more question. address of LTP 2. where i can get it?

27

General Mach Discussion / Re: Can use both LTP Port

« on: April 11, 2007, 11:23:26 PM »

any body try use 2 printer port? how to setting Mach3

28

General Mach Discussion / Re: VFD recommendation

« on: August 23, 2006, 03:31:51 AM »

try yaskawa V7 seri VFD. it had Frequency input

29

General Mach Discussion / Can use both LTP Port

« on: August 15, 2006, 09:26:13 AM »

I want use both LTP 1 and LTP 2, because i want use encoder for xyz axis. Need too much input, 1 LTP just have 5 input. If i use LTP 2 port I have more than 17 input. That right?