Hello Guest it is March 28, 2024, 08:21:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tivoi

Pages: 1 2 3 »
1
General Mach Discussion / Re: Steppers high vibration problem
« on: August 18, 2014, 01:05:39 AM »
check motor wire conection

b.r

2
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: June 22, 2014, 07:32:42 AM »
thanks art

3
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: June 22, 2014, 12:58:49 AM »
where i can get DarWin Timing Engine plugin?
thanks you

4
General Mach Discussion / Re: New computer MOB needs Parallel port
« on: December 06, 2010, 07:34:58 PM »
yes, i think it will work with PCI to LPT card

5
General Mach Discussion / Re: MOD mach3
« on: March 08, 2010, 09:20:59 AM »
thanks hood alot

6
General Mach Discussion / MOD mach3
« on: March 05, 2010, 07:27:12 PM »
How to make keyboard buton can chang feed rate overdrive?

thanks and regards

7
General Mach Discussion / Re: Mach3 modify question
« on: November 26, 2009, 10:00:08 AM »
thanks Hood alot

8
General Mach Discussion / Re: Mach3 modify question
« on: November 26, 2009, 08:53:27 AM »
thanks Hood.

I want mach3 run one line code , and stop , when have signal input, it's run netx line code.

9
General Mach Discussion / Mach3 modify question
« on: November 26, 2009, 12:05:08 AM »
How mach3 can wait extranal input when mach3 finish one line code?

thanks alote  ???

10
test clip

6A 65V, 10 microstep, 1900RPM max, mach3 control, acc 1000mm per ss

<a href="http://www.youtube.com/v/wXwRLE4ohH8&amp;color1=0xb1b1b1&amp;color2=0xcfcfcf&amp;hl=en_US&amp;feature=player_embedded&amp;fs=1" target="_blank" rel="noopener noreferrer" class="bbc_link bbc_flash_disabled new_win">http://www.youtube.com/v/wXwRLE4ohH8&amp;color1=0xb1b1b1&amp;color2=0xcfcfcf&amp;hl=en_US&amp;feature=player_embedded&amp;fs=1</a>

Pages: 1 2 3 »