Hello Guest it is May 08, 2021, 10:01:53 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - switzcheese

Pages: 1
1
General Mach Discussion / switching from Plasma to Mill profile
« on: December 27, 2012, 12:15:54 PM »
Hi. This is my first post to this forum:
 I have been using the Mach 3 plasma profile. My CNC was originally set up for  a plasma cutter, but I have fitted it with a router instead. I have been using it with the plasma profile and it still works fine, but I would like to configure it to work with the mill profile. I have downloaded the mill profile but nothing works with it. Do I just need to copy all of the configurations that are set on the plasma profile, or is there something else I need to do (re-licensing, etc)?  Thanks

Pages: 1