Messages

21

General Mach Discussion / Re: Suggestions for tool offsets and Hi

« on: April 21, 2007, 04:15:13 AM »

pressed of the outer case no problem  have been using the  drives from are euro trade  24 -90 volt 7.8 amp about £80 a drive 

still getting things  set right  at the moment but pleased with results so far


Andrew

22

General Mach Discussion / Re: Suggestions for tool offsets and Hi

« on: April 20, 2007, 04:28:46 PM »

thanks hood by the way the bridgeport steppers I had off you (ebay ) are working a treat thanks for your continued help

Andrew

23

General Mach Discussion / Suggestions for tool offsets and Hi

« on: April 20, 2007, 03:58:04 PM »

First of Id like to say Hi as I’m new to the group and then If someone could suggest the best forums to answer my Questions

The software tools I have are Auto cad 2004  Mach3 lazycam pro and the NFW

The machine I’m using /building/converting is a Clausing Kondia f1
 X and Y axis complete Z axis to do

I did a drawing of a doughnut in auto cad and then set the cut depths in lazy cam and the cut in mach 3 when the cut is done yes you guessed it’s the wrong size by the amount of the tool diameter

I have now brought lazycam pro

But before I start again Id like some help if you can

I must say that the whole software set up is great (lazycam  mach 3 ) keep up the good work

Thanks Andrew Bishop England