Hello Guest it is March 28, 2024, 07:58:35 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wirsboguy

Pages: 1
1
Galil / Re: Which Galil to use??
« on: December 19, 2012, 05:16:00 PM »
The drives are Mitsubishi MR-J2S, which use a  + or - 10v signal, I assume that this would be analog?

2
Galil / Re: Which Galil to use??
« on: December 18, 2012, 08:01:24 PM »
Thanks, Now my next question is, How hard is it to set up the Galil controllers? Do they require some sort of programming. The web site boast's that they are easy with 2 letter commands, but this will be my first experience.
Thanks to all who respond, and hope you have a joyful holiday season.

3
Any experience or opinions with the Apollo board?

4
model is Mitsubishi MR-J2S-40A

5
Yes, they are the S version.

6
You were one step ahead of me.. thanks,  so, does this mean I can use any breakout board to achieve this?
Any preferance on BOBs' ?

8
I have read the manual, several times, Unfortunately I do not have the knowledge (yet) to decipher it.
I have come to the conclussion that it needs -10v to +10v in the speed mode or -8v to +8v in the torgue mode. How do I supply the signal ?

9
Hi, I have Mitsubishi servo's and drives, the drives are MR-J2S. Do I need a motion controller or just a breakout board to get this up and running? I want to use Mach 3 and have been confused by alot of "advice". Thank you for any assistance you can provide me with the wiring, and other hardware needed.

10
Galil / Which Galil to use??
« on: November 20, 2012, 05:29:27 PM »
I Have Mitsubishi MR-J2S-40A Drive and corresponding motors. What would be the easiest controller to use with them and Mach 3?
Thanks.

Pages: 1