Messages

1

General Mach Discussion / Re: used encoder for feedback

« on: November 26, 2012, 06:01:36 AM »

Who is accountable?

2

General Mach Discussion / Re: used encoder for feedback

« on: November 23, 2012, 06:00:40 AM »

I want to count axis DRO with encoder pulse and No with calculation.
for example ,
X Axis will continue to move until X position Encoder  reaches to the destination coordinates .

3

General Mach Discussion / Re: When an input is activated Unwanted output changes

« on: November 23, 2012, 04:47:13 AM »

Thank you for the answer.
I've attached the XML file.
When each of  input and limit switch is activated, Each output may change.

4

General Mach Discussion / used encoder for feedback

« on: November 23, 2012, 01:50:03 AM »

I'm going to use the encoder for feedback on  x,y axes. So the encoder position of  axes appear directly to axes DRO.
What should I do?

5

General Mach Discussion / toolpath is incomplete

« on: November 23, 2012, 01:14:16 AM »

Mach3 v3.043.022  and  v3.043.053   is displayed in the toolpath is incomplete.
And while the gcode in Mach3 v2.63 is displayed complete.
What should I do to fix this problem?

6

General Mach Discussion / When an input is activated Unwanted output changes

« on: November 23, 2012, 12:43:39 AM »

I am using Mach3 v2.63  software.
When an input is activated Unwanted output changes.
Please Help me.