Hello Guest it is January 17, 2022, 05:04:19 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Mr.Horsepower

Pages: 1
General Mach Discussion / laser software
« on: December 11, 2012, 04:54:01 AM »
what I can use with mach3
I need engraving image and text  cut out plate same work And of course easy use and visual :)

General Mach Discussion / laser setings
« on: November 15, 2012, 02:28:17 AM »
hi I want ask  how I can make settings for laser ?

Yes I can make lazy cam code for dxf mode  plasma and run and cut ok

But I want make z axle convert fire for laser beam like that then z go negative beam its start burn and if it go deep give more voltage and more power and z go 0.00 or positive beam end

Or how I get digital trigger work ?

my board tb6550 blue 4 axle

and I use relay for beam control   output 1 pin 2  work ok in lazy cam in plasma mode

do I get z axes data in pin and make transitor circuit swiths run beam ?
but I make vector cut artcam pcb  code and I run in mach work very good milling virtual  works ok

but not work start code and beam not response z control  beam start if I code run and end then code end but not lift up z axle control

Pages: 1