Hello Guest it is September 16, 2019, 07:12:55 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bobwilson84

Pages: 1
1
General Mach Discussion / Re: Travel Direction ?
« on: November 09, 2012, 01:30:33 PM »
Hood,

Thanks !

Bob

2
General Mach Discussion / Travel Direction ?
« on: November 09, 2012, 01:06:06 PM »
On my machine at home, pressing the left arrow button on the keyboard results in Mach3 moving the milling table to the left.

On the Tormach PCNC 1100 at work, pressing the the left arrow button results in Mach3 moving the milling table to the right.

Which configuration of travel is preferrred or correct?

Bob

Pages: 1