Messages

11

Promote and discuss your product / Re: Set Tool Length Offset with our new Setter

« on: December 07, 2012, 08:55:35 AM »

Hey everyone,

We are running a Holiday Special on the TLOsetter - only $89

Happy Holidays

12

Promote and discuss your product / Re: Set Tool Length Offset with our new Setter

« on: November 07, 2012, 08:10:48 AM »

Just got a great question about using the TLOsetter:

If you have a index-able cutter, and or a fly cutter how can you use the touch tool?

Here is the answer:

For any tool that has a cutting point lower than the center of the tool just jog in X and/or Y so that the low point (min Z) is over the contact point of the switch, from there on it works the same.  Start the macro, enter the tool number, and voila, the TLO is now entered in the tool table.

 If you would like to view the TLOsetter User Instructions just let us know, we’ll forward them to you.