Hello Guest it is April 16, 2024, 10:04:31 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - rafterj

Pages: 1
I have some extra switches, should I try to replace the one on the z-axis and the re-reference the table.  I have referenced the table a couple of times since this started and it will work right for sometimes 1 or sometimes up to 50 cuts but then the messages will come back.

HOME switch?  is that the limit trigger switch on the Z-axis?

I don't know what this means.  When the message appears the light next to the Z-axis readout turns from green to red and the z-axis on the table goes all the way up.  I can reference all axis, switch to the coordinates button and sometimes I will not get the message and all is good and then the next time its not.  I have an EZ-Router APC plasma table.  Any and all assistance is greatly appreciated.

Pages: 1