Messages

11

General Mach Discussion / Re: ventric problem

« on: November 07, 2012, 10:27:20 AM »

It is probably part of the problem though only time will tell.

12

General Mach Discussion / Re: ventric problem

« on: November 06, 2012, 03:33:57 PM »

Discovered part of my problem. The shaft for my Y is slipping. Probably after i fix this things should be better.

13

General Mach Discussion / Re: ventric problem

« on: November 06, 2012, 08:29:21 AM »

I tried that and it would not allow me to post it. I will have to post it with a different extension
.

14

General Mach Discussion / Re: ventric problem

« on: November 05, 2012, 07:23:34 PM »

it is supposed to be 24"

15

General Mach Discussion / Re: ventric problem

« on: November 05, 2012, 09:30:14 AM »

Yes it is as if it is losing position. But even on the display (mach 3) the tool path is incorrect. I have done some test to to see if it returns to 0 and that functioned well.

16

General Mach Discussion / Re: Drawing software

« on: November 04, 2012, 07:32:15 PM »

Niot really a model name as it is made by a guy from vancouver.

17

General Mach Discussion / Re: Drawing software

« on: November 04, 2012, 06:37:36 PM »

Tool set to .5 , Melamine, climb cut, inside. 48 by 48 machine

18

General Mach Discussion / Re: Drawing software

« on: November 04, 2012, 04:15:18 PM »

Oh yes and i measured my bit and it measures .493

19

General Mach Discussion / Drawing software

« on: November 04, 2012, 04:14:23 PM »

I am not sure if it is the drawing program, Ventrics 2d of mach3. I draw a circle 4.75 inches in diameter. Save and load into ventrics. create the code and load it into mach 3. now the machine cuts a circle 4.714 inches. I drew the circle with corel draw 11.

20

General Mach Discussion / Re: software restraints.

« on: November 04, 2012, 04:11:27 PM »

Thanks got it to work. 1 problem solved 10000 more to overcome.