Hello Zafar
thanks for the example of the marcopump.
about the EDM wire machine i have development my one small EDM wire machine and it is to make small piece to use a didatical model in school ore for people that it like to use for hobby.
I work whit Mach3 my friend Edu in Brazile whit EMC2 and there is a men Helmut Hummel in Canada I don't now what he use.
So the problems whit Mach3 and EDM wire.
so if Mach3 have to run more as 36 hours you get problems the program stop are it will go out a direction what not is plan.
So the reversing if you have a short circuit I don't use it I have to to do it this way in mach push feed hold start reverse run start go back forward feedhold and then start.
but for a g1 and G0 it will work but not for G2 and G3
But at the moment I control the feedrade whit analog voltage that coms from the generator. I have ask on Art if hee would make some change on the program in Mach 3 for EDm wire like to reverse run but he was not intrest in it.
my website whit some photo
www.microspark.eugreetings Benny if you have some quistions ask it