11
G-Code, CAD, and CAM discussions / Re: Mastercam to Mach Problems
« on: March 15, 2010, 05:06:28 PM »
I’m getting some glitch too.....
I’m Getting : “ Radius to end of arc differs from radius to startLine” ...and it’s NOT so, based on the drawing !?!
How & where is this “ IJ ” mode so I can try to change it to see if this will help me ??
Thanks in advance.
Robert
I’m Getting : “ Radius to end of arc differs from radius to startLine” ...and it’s NOT so, based on the drawing !?!
How & where is this “ IJ ” mode so I can try to change it to see if this will help me ??
Thanks in advance.
Robert