Hello Guest it is October 02, 2022, 03:04:26 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - W.Jansen

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 »
91
General Mach Discussion / Re: Thread Milling Wizard
« on: June 06, 2007, 01:57:52 PM »
Hi Dan

My english is very bad so i cant find the exact words to expres what i mean but you say you machined the insert first , that anwers my question, you did made both threads separate.
Did you made the insert also on a mill or on a latche?
So you made the part on actual size.
Did you use the wizzard of Newflange solutions?

Greetings:
Willem

92
General Mach Discussion / Re: Thread Milling Wizard
« on: June 06, 2007, 01:18:42 PM »

Wow, not bad at all.
In and outside threads made in one tighten ????
Is this pen on real size?
Nice job man.

Greetings:
Willem

93
General Mach Discussion / Re: Thread Milling Wizard
« on: June 05, 2007, 10:00:26 AM »
Hi Dan

Can you post the real pieces aswell ?
Very curious.

Greetings:
Willem

94
General Mach Discussion / Re: Initial Setup
« on: June 05, 2007, 08:36:29 AM »
Hi James

Go to "config"in the upper left corner "motor tuning" that will make a lot clear , do not forget to enter after every changes.

Greetings:
Willem

95
LazyCam (Beta) / Re: Front side turning
« on: June 02, 2007, 09:53:42 AM »
Thanks Brian

Would be nice.

Greetings:
Willem

96
LazyCam (Beta) / Re: Front side turning
« on: June 02, 2007, 06:01:22 AM »
Hi Brian

Sorry i don't understand.
Maybe i did not expres myself clear i have a drawing attached with a frontview (yellow line's).
The inside is no problem , the outside is also no problem but i do not see how to make this shape on the front.

Greetings:
Willem

97
LazyCam (Beta) / Front side turning
« on: June 01, 2007, 05:33:45 AM »
Hi Art and Brian

Is there a chance you can spend a little bit attention on front side turning.
I find it diffecult to make a shape on the front side of the material.

Greetings:
Willem

98
LazyCam (Beta) / Re: Zoom box
« on: May 28, 2007, 11:44:17 AM »
Hi Brian

Yes the problem is solved but it would be nice if a minimum size of the zoombox is required to activate the action.

Greetings:
Willem

99
LazyCam (Beta) / Re: Zoom box
« on: May 23, 2007, 02:40:08 PM »
Ah why did i not think of that.
Thanks Klmark.

Greetings:
Willem

100
LazyCam (Beta) / Re: Zoom box
« on: May 23, 2007, 12:33:53 PM »
Hi Klmark

Yes i know thats how to do it but i meant if i forgot to drag and just release the mouse button then my object is gone.
Thats a big punish for such a smal mistake.

Greetings:
Willem

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 »