Messages

81

LazyCam (Beta) / Re: Front side turning

« on: November 11, 2007, 10:42:03 AM »

Hi Brian

I can imagine that it is a difficult question (not the question but the solution).
I appreciate your effort in this.
To me it would be a great progression in Lazycam if it would be possible.

Greetings:
Willem

82

LazyCam (Beta) / Re: Front side turning

« on: October 23, 2007, 09:31:09 AM »

Hi Brian

Is it still on the list?

Thanks and greeting:
W.Jansen

83

Share Your GCode / Re: GCode Sharing

« on: July 17, 2007, 05:45:47 AM »

Hi Art

What shape has the tool to cut this item?

Greetings:
W.Jansen

84

General Mach Discussion / Re: cannot get encoder or mpg to work, need help

« on: June 21, 2007, 03:01:53 PM »

Thanks Chip

I take my chance and give it a try , in the worst case it can cost a lpt board.


Greetings:
Willem

85

General Mach Discussion / Re: cannot get encoder or mpg to work, need help

« on: June 21, 2007, 02:24:09 AM »

Hi Chip

My mistake , the output signal is of course stabilized.
Bud how about a resistor in series with A-B , shall that be necessarily and if yes what value should it have?
I ask this becourse my intention is to use two encoders for MPG purpose and i dont like to add a seccond break out board.

Greetings:
Willem

86

General Mach Discussion / Re: cannot get encoder or mpg to work, need help

« on: June 20, 2007, 06:24:58 AM »

Hi all

Will 6 volt not destroy your port if no precautionary measure is taken?
If i want to put an encoder directly to the port do i need to put a resistor in series with the a and b channel?

Greetings:
Willem

87

General Mach Discussion / Re: magnetic home switches

« on: June 13, 2007, 12:59:58 PM »

Hi Stirling

Yes 2.00.076 is a develepment version but what i have read somewhere in the forum this version is more stable then 2.00.065

Greetings:
Willem

88

General Mach Discussion / Re: magnetic home switches

« on: June 13, 2007, 11:29:46 AM »

Hi stirling

No 2.00,065 is not the latest.
If you go a little more down you see version 2.00.076 that is the latest.
The suggestion from Chip was a good one?
So a another happy user?

P.S.
If you are going to cut ferro metals magnetic switches are not the best home switches.
Chips can hit the switches and greate that way errors.

Greetings:
Willem

89

General Mach Discussion / Re: magnetic home switches

« on: June 13, 2007, 08:42:54 AM »

Hi Stirling

I have deleted mi message because i think the answer of Chip is the correct answer.
Bud you have an old version of Mach3, a lot is changed since version 1.84.
Maybe it is a good thing to get the latest version.

Greetings:
Willem

90

General Mach Discussion / Re: Thread Milling Wizard

« on: June 06, 2007, 02:25:05 PM »

So you see , work can be fun.

Greetings:
Willem