Messages

51

G-Code, CAD, and CAM discussions / Re: G-Code scaling program, mm to Inches and back

« on: July 22, 2008, 03:37:35 PM »

Hi Graham

Your program works perfect for me, thanks very mutch.
Just out off curiosity, what is the difference between the two versions?

Greetings:
Willem

52

LazyTurn / Re: LazyTurn

« on: July 14, 2008, 04:36:31 PM »

Okee Graham

I understand.

Greetings:
Willem

53

LazyTurn / Re: LazyTurn

« on: July 14, 2008, 02:51:15 AM »

Hi Art

Where will I be able to download the dxf for the chess piece that you use in Lazyturn?

Greetings:
Willem

54

LazyTurn / Re: LazyTurn

« on: July 09, 2008, 02:26:06 AM »

Wow

Looks better then A sex video.

Thanks Art

Greetings:
Willem

55

LazyTurn / Re: LazyTurn

« on: June 10, 2008, 01:56:43 AM »

Thanks Art

Sorry for the impatience.

Greetings:
Willem

56

LazyTurn / Re: LazyTurn

« on: June 01, 2008, 12:50:11 PM »

Hi Art

I know there is A lot turbulence on the mach3 front but do you still see light on the end of the Lazyturn tunnel?
It is so destroying silence around here.

Greetings:
Willem

57

LazyCam (Beta) / Re: No tabs

« on: May 28, 2008, 03:07:34 AM »

Hi Curtisu

If I may asc, did you use offsets in your project?

Greetsings:
Willem

58

LazyCam (Beta) / Re: No tabs

« on: May 19, 2008, 02:46:22 AM »

Hi Chip

Tabbing seems OK now (altough I see 2 tab in stead of 4 , see yellow windows) bud if A post and run the file Mach3 will not cut as it suppost.
It will not allways cuts the little path (see the red windows) bud rounds the complete circle and sometimes it cuts them.
Also the depth are not Watt they suppost to be.
A can explain it not good bud if you run the file (I only made tabs in the second item) you see Watt I try to say.

Greetings:
Willem

P.S.

The Lcam project with tabs can not be saved for some reason

59

LazyCam (Beta) / Re: No tabs

« on: May 19, 2008, 02:01:31 AM »

Hi Chip

Thanks it was A stupid mistake, the depth of the tab I made 0 COMMA 4 mm and it should be 0 dot 4.
It would be nice if Lazycam give A note that A comma is not allowed.

Greetings:
Willem

60

LazyCam (Beta) / No tabs

« on: May 18, 2008, 05:53:33 PM »

Hi Brian

Finely I have A reasonable Lcam file bud I cant create tabs in it.
I try to create tabs 2mm long 0,4mm high and 2,3 or 4 tabs per item.
I think it has somethink to do with multiple pass cuts because i made A similar file that cuts in one pass and there works tabbing fine.
I send here the Lcam and the tap file.

Greetings:
Willem