Messages

1

Mach4 General Discussion / Re: Cutting corners, Mach4 versus Mach3

« on: September 25, 2023, 02:54:11 PM »

Thank you Goomba
So the cure is to run CV tuning wizard ?
Do you allso have a link to a G-code manual ?
Poul

2

Mach4 General Discussion / Cutting corners, Mach4 versus Mach3

« on: September 25, 2023, 02:32:21 PM »

Please help. I am just about to return to the ever working Mach3. Here is the problem:
I make my drawings with Fusion 360 and the G-code with V-carve pro 6.5
I have drawn a simple square of 100 x 100 mm. Sharp corners. The router is Ø 2mm.
When i cut with Mach3 i get corners with a radius of 1mm.
Making the same cut with Mach4, the corners have an radius of about 7mm.
Best regards
Poul

3

SmoothStepper USB / ESS285 motor "counts per unit"

« on: August 19, 2023, 03:19:59 PM »

Please help
 My Mach3 pc collapsed, and I have strugled for many hours to setup Mach4 /ess with my cnc router. With no succes
How do i enter the "counts per unit" for each axel in control config. All the fields are gray.
Best Regards
Poul

4

General Mach Discussion / Re: Strange extra cuts with R3.043.066

« on: October 17, 2012, 02:00:44 PM »

Hi Hood

That solved the problem. Thank you. The question is now why. Can you give some explanation to help me in the future? The code was generated by Cut3d.

Best Regards Poul Munch Andersen

5

General Mach Discussion / Strange extra cuts with R3.043.066

« on: October 16, 2012, 04:33:29 PM »

Mach 3 with release r.3.43.066 and r3.43.056 produce some extra circles thar are not in the project. Release r3.042.020 do not do these extra unwanted circles. File with code attached.

Best regards
Poul Munch Andersen