Messages

41

General Mach Discussion / Re: Driver test

« on: June 09, 2013, 01:38:27 PM »

My mistake no numbers moving and try getting rid of the estop but nothing works

42

General Mach Discussion / Re: Driver test

« on: June 09, 2013, 08:41:41 AM »

I went back to the smoothstepper usb because I am running windows 7 64 bit. It seems to be working but nothing moves except the numbers on the screen, I cannot get rid of the estop, I dont even have one operating yet

43

General Mach Discussion / Re: Driver test

« on: June 08, 2013, 10:16:42 PM »

What numbers do I put in for the port address all It shows is lpt3

44

General Mach Discussion / Driver test

« on: June 08, 2013, 07:28:32 PM »

Tried using a smoothstepper but I could not get it to work so I went back to a port.I go to set the port setting but in control panel it does not show one all it has are LPT's, also I cannot run driver test

45

General Mach Discussion / Re: Computer shuts down

« on: October 21, 2012, 03:36:57 PM »

Working fine the last 2 days

46

Mach3 under Vista / Computer shuts down

« on: October 20, 2012, 10:25:59 AM »

Running Windows7 and everytime I have Mach3 open The computer shuts down. When I start the computer back up I receive a startup repair screen, I run that then the computer shuts off. When I start it up again it goes right to the windows desktop. Any ideas?

47

General Mach Discussion / Re: Computer shuts down

« on: October 20, 2012, 10:15:51 AM »

Just clicked on restart and again computer is running but nothing in screen. Can I take and put mach3 on another computer?

48

General Mach Discussion / Re: Computer shuts down

« on: October 20, 2012, 09:57:18 AM »

Just clicked on restart computer and the computer came on but nothing on screen.Had to turn off then on. When I do this the first time I receive a startup repair screen, it runs then click finish and the computer shuts off. When I start it up again it starts fine

49

General Mach Discussion / Re: Computer shuts down

« on: October 20, 2012, 09:46:32 AM »

Windows7 and I have power options set to never

50

General Mach Discussion / Re: Computer shuts down

« on: October 20, 2012, 09:18:38 AM »

Have not seen it . I started it last night  and today it was still running but the computer had a dark screen had to shut down and restart the computer. Restarted Mach3 today and it is still running but had to go to msconfig and turn off load startup items