Hello Guest it is March 29, 2024, 11:30:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Apollo ll

Pages: 1 2 3 4 »
1
CS-Lab / Re: First impressions of CSMIO/IP-A (analogue output version)
« on: August 11, 2013, 03:33:10 PM »
Hood,
Iam sorry but I think I sent the wrong one.
See this one looks better?

Thanks,
Apollo ll

2
CS-Lab / Re: First impressions of CSMIO/IP-A (analogue output version)
« on: August 10, 2013, 10:44:05 PM »
Hood,
The machine I have is a Bridgeport Apollo ll. It is a 3 axis cnc knee mill. 1993 vintage.

Thanks,
Apollo ll

3
CS-Lab / Re: First impressions of CSMIO/IP-A (analogue output version)
« on: August 10, 2013, 10:41:44 PM »
Hello Hood,
Trying again.

Thanks

4
CS-Lab / Re: First impressions of CSMIO/IP-A (analogue output version)
« on: August 10, 2013, 04:38:41 PM »
I will try once more.

Apollo ll

5
CS-Lab / Re: First impressions of CSMIO/IP-A (analogue output version)
« on: August 10, 2013, 04:27:24 PM »
Hello Hood,
I can not send the xml file. It says I already submitted that post. Any ideas how to send it?

Thanks,
Apollo ll

6
CS-Lab / Re: First impressions of CSMIO/IP-A (analogue output version)
« on: August 10, 2013, 02:05:25 AM »
Howdy Hood, I have several issues that I could use your advise on.
1) On a CS-MIO--IP-A to an Apollo II hook up what is the wire to pin configuration when connecting the analog X, Y and Z (+/-10v) to the Axis Drive Boards? I am not getting ten volts from the outputs to control the Axis Drive Boards. Am I supposed to supply voltage some how or is the CS-MIO supposed to supply it?
2) What do I hook up the spindle break to?
3)I have my eject tool function hooked to output 1. How do I tell the Mach III program what that port is so it can control it, and the same with all the outputs?
Thanks a ton.
Apollo ll

7
Hey Hood, Sorry to bombard you with all these questions but I sure do appreciate the help. It will be great to see this in action once it is done. Along with the Proximity switch I am trying to tie in the last of the spindle control. The spindle speed control signal says it takes a 0 to +/- 12v analog but the CSMIO only has +/- 10v analog. Does that hook to the analog +/- 10v or the analog 0-10v output. And will it affect the actual speed since it is 10v instead of the 12v that it was originally.
Apollo ll

9
The web site I found it on is, www.datasheets.globalspec.com
Part # EGT 12x02AP024-SEM4

Apollo ll

10
Hello Hood,
As far as the axis motion, and the jog switch Im going to order the MPG Module and pendant from CS Labs.
You were right it is a proximity switch. Part number EGT12x02AP024-SEM4. It looks like it will handle 30volts, and 250ma. Im not sure how to hook it into the CSMIO though?
Any ideas?
Thanks for all your help!

Apollo ll

Pages: 1 2 3 4 »