Messages

11

General Mach Discussion / Re: Z- slow jog key (left arrow) stopped working

« on: October 03, 2012, 12:55:01 PM »

Got it.  Thanks.

John

12

General Mach Discussion / Re: Z- slow jog key (left arrow) stopped working

« on: October 03, 2012, 11:08:44 AM »

 Not sure how to put 999 in that field, however, if I change it to anything else the jog keys all work now.  I thought that field only displayed the keyboard scan code and that you could not manually enter data into it.

Thanks again, problem solved.

John

13

General Mach Discussion / Re: Z- slow jog key (left arrow) stopped working

« on: October 03, 2012, 08:54:08 AM »

My xml attached, I noticed that the value for ListKey is the same as AxisKeys5.  Might that be causing a conflict?  I also attached a screenshot with the jog flyout open.  Again, slow jog for both x directions and z+ works fine, as well as fast jog for all four directions, just no slow jog for z-.

Thanks.

John

14

General Mach Discussion / Re: Z- slow jog key (left arrow) stopped working

« on: October 02, 2012, 04:42:14 PM »

I don't think it's the keyboard because it works fine on a rapid jog (shift + left arrow) or when editing in notepad, just the slow jog is not functioning. 

John

15

General Mach Discussion / Z- slow jog key (left arrow) stopped working

« on: October 02, 2012, 11:07:30 AM »

I have learned much about Mach3 from this forum.  I converted a South Bend lathe to cnc and it has been working resonably well, (except for some occasional lockups).  Recently, my left z- jog (slow jog only) stopped working from the keyboard.  The confusing thing is that it still works from the flyout menu and fast jog (shift + left arrow) still works.  This is rather confusing and makes setup frustrating to switch between using the mouse and keyboard to get set up.  Any thoughts?

John