Hello Guest it is March 31, 2020, 09:36:01 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - lampadas

Pages: 1
1
Look ....... I have run the brushless .. Success ....

http://m.youtube.com/watch?v=R8BNassPiqs&feature=c4-feed-u

2
Ok thnx for the answers  I will try .. And I will  inform about the results

4
Not only resistors, kind of IC on the bottom.
1.5 to 2.5 msec pulsewidth PWM.
found this on YouTube

http://www.youtube.com/watch?v=DUzuEt8fmJ8

The Pokeys device has adjustable PWM outputs.

Alex
I think this is  PIC16F629 and I thing pg must be programmed ....     

5
Here's the answer for non electronics wizards (such as myself) that can't build their own.  http://www.logicnc.com/rcnc.html
I know this solution but it is not cheap.if you look the video this man use the brushles motor and the esc only . And some resistors . How can I make this

6
Interesting question which I'm curious to hear a learned response to.  I've run R/C planes, boats & cars for 40 yrs without knowing much about the magic "behind the scenes."  This link explains a bit about how they work.  http://en.wikipedia.org/wiki/Servo_control

Seems like a simple task for Mach, yes? ;D
I don't know if it is  simple task but I can do  the motor run... I  think mach doesn't  produce in this frequency pulses

7
What type of input signal does the speed controller require, PPM, PWM or just variable frequency?
esc need pwm signal.. Every 20ms

8
Hi .. Can Anyone tell me how can I do this .....  I want controll a brushless motor with mach3

I have this esc ...http://www.helipal.com/hobbywing-skywalker-40a-esc.html


Look this ..
http://m.youtube.com/watch?v=FxtAkQ0uljE&desktop_uri=%2Fwatch%3Fv%3DFxtAkQ0uljE


 Thanks .

9
General Mach Discussion / HI I HAVE A QUESTION
« on: September 19, 2012, 11:19:04 AM »

Pages: 1